Doug, Thanks for info. I removed carb, then click screw, so can easily see the hole where the ball and spring should go. I don’t have either but will inquire locally. I think the leak is coming from where the shaft goes into the bottom of carb, and turning, adjusts the richness. There seems to be a pressure fitting there with only a bit of graphite — no gasket material. I will look in my Book of Info before bugging you about enrichener linkage details.
Also — gasket between carb and block was cork — cracked. I suppose cork is not the right material here? I have other more normal gasket material.
Thanks again, Mike Barnes, Vancouver
|