View topic - master cylinder configuration

dodgebrothersclub.org
http://dodgebrothersclub.org/phpbbforum/

master cylinder configuration
http://dodgebrothersclub.org/phpbbforum/viewtopic.php?f=3&t=562
Page 1 of 1

Author:  PaulHossfeld [ Mon Apr 29, 2019 10:13 am ]
Post subject:  master cylinder configuration

I have a 1932 f10 chassis with a 1 piece master cylinder/fluid reservoir. Is this correct or should it have a separate reservoir from the master cylinder?

Author:  TomShultz [ Mon Apr 29, 2019 10:07 pm ]
Post subject:  Re: master cylinder configuration

Both type were used . I seen with out remote on other panel type F-10

Author:  PaulHossfeld [ Tue Apr 30, 2019 8:32 am ]
Post subject:  Re: master cylinder configuration

thanks Tom, Mine has a single but was modified slightly to fit. When I looked it up I found that both types were listed. I am going to start working the brake system and wanted to know what I should look for if replacements are needed. In that mine is slightly modified I will probably just get the replacement anyway.

Do you know if the light switch is in the master or on the pedal? Mine is electrically working off a pedal switch but the master also has the pressure switch on it.

Thanks
Paul

Author:  TomShultz [ Tue Apr 30, 2019 10:35 pm ]
Post subject:  Re: master cylinder configuration

Mine has reservoir can and ps on top of it . Most take standard rebuild kits base on dia. . Only if corrosion has ruined inside may you need to have it sleeved .


Attachments:
20190428_142315.jpg
20190428_142315.jpg [ 1.63 MiB | Viewed 11599 times ]

Author:  PaulHossfeld [ Wed May 01, 2019 12:17 pm ]
Post subject:  Re: master cylinder configuration

thanks

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/