View unanswered posts | View active topics
|
Page 1 of 1
|
[ 3 posts ] |
|
Author |
Message |
RussellRogers
|
Posted: Mon Feb 08, 2021 7:16 pm |
|
Joined: Sat Oct 05, 2019 6:00 pm Posts: 2
|
Help! I am installing the sealed bearing upgrade. Does this mean I leave the cork seal out of the front and the o-ring out of the rear? Thanks, Russell
|
|
Top |
|
|
rickbrinker
|
Posted: Tue Feb 09, 2021 3:30 pm |
|
Joined: Wed Aug 03, 2016 6:57 am Posts: 50
|
I opened the front of the bearing and left the seal on the back
|
|
Top |
|
|
RussellRogers
|
Posted: Tue Feb 09, 2021 7:35 pm |
|
Joined: Sat Oct 05, 2019 6:00 pm Posts: 2
|
Are you saying you removed the bearing shield on the inside of the transmission and left the shield on the outside facing the clutch and the universal joint? Some thing else I am concerned about is if I install the front bearing washer,cork seal and cover with the 3 wired bolts , is that they would receive no lubrication ! Should I just leave these components off ? I am not as worried about the rear as it will get get lubrication from the universal joint grease!
Thanks, for you reply
|
|
Top |
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 100 guests |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|